This bracket fits the 2015-2017 Corvette Z06/Z07 stages 2 and 3. Constructed of 5052 and 6061 aluminum, welded and painted trim black, this bracket is built to last. Comes with a limited life time warranty. All parts required for installation included, however, tools are required. Requires 2 holes to be drilled on the underside of the vehicle. These holes are not visible and do not detract from the look of the vehicle. Made in USA
Product Features
- Easily mounts under front valence using factory screws, add more support with included bolt
- Mounting hardware & easy-to-follow instructions included
- Frame is made of aluminum including the quick-release pins
- Pull a pin and your car is showroom ready, then click the license plate back in and drive home
- Fits: 2015 Corvette Z06/Z07 Stage 2 and 3, 2016 Corvette Z06/Z07 Stage 2 and 3, 2017 Corvette Z06/Z07 Stage 2 and 3
Excellent Plate mounting solution Very easy install. Took 10 minutes. Need access to the underside of the nose of the car – a lift is recommended to drill the two holes. Mounts the plate below the front grill area to allow for proper airflow into the intercooler and radiator. Highly recommended if you have a Z06 with the Stage 2 or 3 aero kit.
Great design but tolerance are not good Great design but tolerance are not good, or I received a bad product. The male end is very difficult to insert and remove from the receiver. Even tried sanding the rods and putting lube on them and still very difficult to take on and off.
Perfect fit and ten times better then stock! Loved the ease of installation and the fact it’s so easy to remove the plate and you basically cannot see the mount. Plus very sturdy.