Upgrading to a Tork Master torque converter with a higher stall speed can give you better acceleration from a dead stop. It allows the engine to launch the car at a higher RPM, where more torque and power are available. This can be especially important if other modifications (like larger cams) have reduced your low end power and torque. The Tork Master 2000 has a stall speed of 1900-2100 RPM (based on an engine producing 230 lb. ft. of torque at 2500 RPM), so it is best suited for mild performance applications, such as vehicles with minor engine modifications that don’t produce more than 350 horsepower. It has been rebuilt with a new precision alloy steel pump drive tube, and it is pressure tested and fully balanced Please Note: High stall torque converters can build extra heat, so supplementary transmission cooling is recommended to avoid premature transmission failure. This converter should not be used with a transbrake, and it requires a small (10-3/4″) bolt circle flexplate or dual pattern flexplate.
Product Features
- Replaces stock converter for better launch capability and more strength
- Value priced upgrade for mild performance applications and street rods
- Stall speed of 1900-2100 RPM (based on an engine producing 230 lb. ft. of torque at 2500 RPM)
- High quality remanufactured unit features a new precision pump drive tube
- Backed by the manufacturer with a 1 year limited warranty
- Bolt Circle Diameter – 10.75 INCHES
This converter is great direct fit in my 70 buick skylark with 350 engine and th350 trans During the purchase of this converter I was very afraid due to all the other reviews I’ve seen I can honestly say as an ASE certified master technician that this converter fit perfect in every way the bolts were perfect the spacing was perfect and the engagement to the front pump was spot on.
Five Stars It works good
good quality product good quality product, bolts up to my 153 tooth flexplate with 10 3/4 / 10.75 bolt pattern. slides right into my th350 no problem, the paint is kind of weak and it did FLAKE off in several places when i was installing, not a big deal though. b&m makes a quality product