C6 Corvette Front Lower Complete Spoiler 3 Sections Fits: 05 through 13 Corvettes

These Spoilers give your Corvette a factory-fresh appearance and restore proper air flow through your radiator, solving many cooling problems. C6 reproduction installation is the same as the factory spoiler on your car. Reuse your stock mounting hardware.

Once PERFORMANCE CHOICE realized General Motors had discontinued the C6 front spoiler and only offered a generic service replacement they set out to reproduce a better replacement option over the generic service replacement kit. Their exclusive 2005-2013 Corvette Front Spoiler does not require any special installation and will mount up using the same hardware and mount points as your stock spoiler and it will fit all 2005-2013 C6 Corvettes.

The center section is a perfect match except the GM part number to the original center spoiler. The side sections are made of rigid plastic and does not offer the same flexibility as the stock side sections found on some C6 years. At this time we believe this is the only aftermarket option out there.

This spoiler kit will fit all C6 2005 – 2013 Corvette’s including coupes, convertibles, ZO6, ZR1 and Grand Sport. The kit does not include the mounting hardware, please reuse your stock mounting hardware when you install your new spoiler kit.

Product Features

  • Fits All C6 Corvettes from 2005 through 2013
  • Low Cost Option over GM.
  • High Quality Reproduction of the Stock Front Lower Spoiler Kit
  • Quick to install.
  • Made by Performance Choice.

2 thoughts on “C6 Corvette Front Lower Complete Spoiler 3 Sections Fits: 05 through 13 Corvettes”

  1. Yeah, a good part, just don’t ever scrape your spoiler For the money it cost I should have stuck with original instead of reproduction. Let me start by saying that the material seems quality. The sticking point, or weak spot, is where the two side pieces meet up with the center. Anyone who owns a C6 knows that the potential for scraping the lower spoiler is high, and will eventually happen. The holes that are punched in the ends of each side piece to attach it to the center are not cut well, and too close to the end of the part. What happens…

  2. Add more attaching hardware if….. They work good…..If you can keep them on. Don’t be satisfied with just the stock attachments, add more!

Leave a Reply

Your email address will not be published. Required fields are marked *