Just what the General (should have) ordered! This front manual retractable plate is the answer to every C7 Corvette Stingray (will not fit the C7 ZO6 or Grand Sport) owner’s prayers. Keeps local authorities and you happy and your Corvette looking clean and uncluttered.
Well-engineered bracket mounts under the front bumper in the center. Designed just for your C7 2014 and Newer Corvette Stingray (NON ZO6 or GS) the mount kit will only require one small hole to be drilled about 10″ back from the front of the bumper out of sight. The remaining mount points will use the GM factory bolt locations already on your Corvette. Your license plate manually slides out and flips up to be viewed, but when at a show, the plate can be flipped down and slid under the front bumper – out of sight. A quality part that solves the front plate driving dilemma. This unit is made by Altec and offers the smallest low profile foot print under the bumper that can be found at just 1.3″ thick by 10″ long.
PLEASE NOTE: Designed to fit the C7 Corvette Stingray only and will not fit the C7 ZO6 or GS. We do offer this item with the mount kit that is designed for the C5 or C6 Corvette in our other listings.
We also offer a powered retractable plate bracket, which can be found in our other listings. This listing is for the manual retractable front plate for your C7 Corvette Stingray (NON ZO6 or GS). This kit should not be operated when the car is motion above 5 MPH and is designed to permanently fail in the plate up position (plate showing) to prevent it’s use to illegally bypass traffic enforcement equipment or hide your plate from other drivers or law enforcement.
Product Features
- Fits the C7 Corvette Stingray 2014 and Newer (Non ZO6 or GS).
- Well-engineered bracket mounts under the front bumper in the Center.
- Manually Extend the Front Plate to View and Retract when Not Needed.
- Complete Instructions are Included. Requires a single hole to be drilled deep under the front bumper.
- Made by Altec.
Great! Installed this today in about 20 minutes. I didn’t need ramps or a jack, just a right angle drill … For the one hole I had to drill. I’m thrilled that the state of NJ hasn’t ruined the front of my beautiful Stingray.
Better than GM OEM plate holder Fits like a charm and looks better than the GM/Chevy OEM plate holder.
Fairly easy to install Fairly easy to install, but requires lifting the car but I had a 90 degree drill attachment. Sticks out front a little farther than I like but does not scrape on curb. Otherwise a good product.