Red LS2 6.0L V8 emblems are Approx. Width 4.25 “inches x Height 1.30” inches [108.0 mm x 33.0 mm]. These emblems are made of high-quality, aircraft thin aluminum and hard-anodized finish for a long-lasting result. It comes with self-adhesive 3M tape for easy, simple installation. It can be installed in ANY smooth surface inside or outside any vehicle. Imported from Japan. You can install this emblem on the trunk, fenders, interior console, etc. *Note: They also looks great as a face emblems on cell phones, laptops and computers. **Note: Surface must be clean and dry prior to adhering. ***NOTE: Please Note that these are NOT the cheap Vinyl and Decal Emblems sold by most on the Internet. These Emblems are made of high quality ALUMINUM and are noticeably different.
Product Features
- Not the cheap vinyl and decal emblems commonly found on the Internet. Noticeably better quality! Made with Special Thin, 3D Embossed Aluminum.
- Quick and easy installation! Approx. Width 4.25″ inches x Height 1.30″ inches [108.0 mm x 33.0 mm]
- Aircraft-quality T-6061 Aluminum. 100% weather proof. Highly Polished Aluminum.
- Hard-Anodized in Color for a Long-Lasting Finish. High-Quality OEM Emblem. Comes with 3M Self Adhesive backing. Ready to stick on ANY flat, clean and dry surface.
- Compatible with GM General Motors Performance Chevy Chevrolet CHEVY CORVETTE SSR ZR1 2005 2006 05 06 PICK UP HOLDEN HSV VAUXHALL Cadillac CTSV Pontiac GTO Chevrolet Trailblazer SS 06 07 08 09 2006 2007 2008 2009 Saab 9-7X Aero crate swap race
Where do i get more exactly like this? These emblems came exactly like they were desribed. They did however fade quit quickly. I ordered them again and got a totally different emblem. It was much smaller and the font was different. Where do I get the right ones?
Emblems look OEM and very nice pieces. Thin but no problem just be careful … Emblems look OEM and very nice pieces. Thin but no problem just be careful not to bend installing. Good quality adhesive tape . clean well surface before install. I heated both surfaces slightly with a heat gun. Could use a hair dryer .May want to put down a strip of masking tape as a straight guide line. Do not try to pull up once you touch down as you will only bend them. You should be happy with these. We will see how the colors hold up.
great looking I used these badges on the outside body and the dash, looks awesome, great adhesive, so make sure you know exactly where you want them! No getting them off without destroying them.