FIAMM AM80SX LOW note two terminal Freeway Blaster features aluminum coil motor, corrosion resistant steel housing and an ABS plastic projector.
Product Features
- FIAMM AM80SX LOW note two terminal Freeway Blaster features aluminum coil motor, corrosion resistant steel housing and an ABS plastic projector.
- FIAMM horn package Includes: Universal mounting bracket, jumper wire, nut and female connectors
- Each FIAMM horn is tested to assure maximum performance and exceeds SAE and OEM specifications
- FIAMM horn can be installed on any vehicle, UTV, ATV, or Motorcycle
- FIAMM two terminal horn, 12 volt (Max amp draw 6) produces 130 decibels @ 4″
Great Motorcycle horn! I own a Suzuki dr650 (dual sport) and I wanted something to replace the overly heavy Rude Boy (very large after market unit) horn that had given up the jig. Being a little more wise, I set out to find a high quality horn that’s much smaller than the last unit I put on the bike.Being that this horn is pretty compact, lightweight, and is made in the USA, I cannot ask for more. I installed it in less than 15 minutes and didn’t even need to fabricate anything, I just used the mount…
Buy This Horn! Bought this as one of the matched pair of Freeway Blasters about six years ago. They were both pretty anemic sounding under the hood of my GMC 3/4, so I added a relay at the underhood fuse box and used it to feed power via a heavier gauge wire from a bolt terminal. They immediately got very loud and haven’t quit yet! They’ve been submerged only once so I don’t know if they were spared by an air block or not. A lesson learned in showing that a very loud horn pair may need a better-than-OEM…
Great safety upgrade for original equipment horns on motorcycles! I own a Honda motorcycle and the factory horn made a pathetic “Road Runner” beep beep sound. It was not loud enough to get the attention of drivers who for one reason or another aren’t paying attention and pose a safety hazard. While not as loud as an air horn, this is still a lot louder and with a deeper tone than the factory horn. I did have to bend the factory mounting bracket to get it to fit as it is slightly bigger than the original horn, but the factory wire connectors fit…