FEATURED Genuine GM Accessories 19170234 Front and Rear Molded Splash Guard
- Fits: 2013 GM Corvette
- Molded Splash Guards
- Black
- Front and Rear sets
- Designed to accent the exterior
Designed to accent the exterior of your Corvette, these Molded Splash Guards fit directly behind the front and rear wheels to help protect against tire splash and mud.
it will prevent the majority of the crap your tires would otherwise kick up onto your fenders …,
the install is a breeze, too. took me an hour, and I was taking my time. I love it when 3m tape is already pre-cut and they have pull tabs ready for you. the fronts install super easy – they re-use your stock popits and you can just turn your wheel to make room for the install. the rears take a tiny bit of work – you will need to jack the car up (make sure to read your manual and use the proper jacking points – use a small piece of wood or a hockey puck for better piece of mind when utilizing the side jacking points), remove the wheels (one at a time is fine), and you have to drill a few holes. fear not, you’re only drilling into the wheel well liner, nothing into the car. the install calls for an awkward size drill bit (24/64th or something similar to that nature) – I just used a 1/4th inch and bored it out some until the push-in popits sealed correctly. don’t try to force them in too hard, if they aren’t going in gracefully, your hole isn’t big enough yet.
Was this review helpful to you?
Looks cool,
Was this review helpful to you?
Good fit, looks great.,
Was this review helpful to you?