Product Features
- *** No Vehicle Specific / Measure To Ensure Fitments – 67″L x 21″D ***
- *** Strut Rods Are Required For Installation (Not Inlcuded) ***
- Material: Poly-Urethane (PU)
- Hardware: Included
- 3M Double Sided Tape is REQUIRED for Installation (Not Included)
Flexible, but durable and blends in with the black parts of my bumper. This lip looks great and has a smooth finish on top. It isn’t completely solid as it it recessed underneath, which makes it pretty flexible. This does allow you to hide your mounting hardware so it won’t stick out, but you need to make sure you secure it well to the bumper and reinforce the edge using support rods. My setup was a little difficult because my bumper has a 3′ raised section in the middle, so I had to use aluminum spacers that were 12″ apart to keep it level with the outer edge…
Think twice I installed this diffuser on my 2004 3.0 v6 Mazda6. The problem with this diffuser is that it is too flimsy, it looks sturdy in the picture but itâs acually really flimsy cheap plastic. I would advise the seller to show the underside of the product so you the consumer can see what quality it is. I bought strut bars for the diffuser. However because of how thin and flimsy the diffuser is, going over 55 or 60mph will ripper your diffuser off from all the air pushing it down. Mine only lasted 3…
Not a 5 minute job. Only reason I give this a 4 is cause it hasnât been driven with it on it yet and the difficulty of getting everything lined up perfectly. The size of this monster is fairly large and on my Maxima it looks huge under that front bumper. Have to drill all mounting holes and line up the splitter on the bumper. (Takes a lot of time to get it right) but itâs very flexible on how much lip you want sticking out all you have to do is slide it further under the vehicle or pull it out. Will update once…