Buy with 2 pcs of extremely super bright high power CSP H10/9145 white LED Bulbs, especially designed for upgrading the stock halogen fog light lamps or DRL lights, or any stock 10/9145 bulbs.
Features:
– Cross Reference Number: H10,9145,PY20D,9040,9045, 9050,9055,9155
– 6 pieces white Seoul CSP chips, 3 pcs each side.
– Pure white light for Fog / DRL lights, Corner lights or any bulbs is H10/9145 type.
Specs:
– Number of Bulbs: 2 pcs
– LED Source: 6 pieces white Seoul CSP chips
– Life Span:50,000+ Hours
– Easy installation, just plug & play
– Faster on/off response time and vibration resistant
Package included:
– 2 X LED light bulbs
Note:
* Load resistor may required to avoid hyper flash or error code for some high powered vehicles or those cars with built-in canbus system.
Product Features
- Seoul Y19 Chip, CSP focused beam technology, Perfect Light Pattern without dark spot.6000-6500K white, DOT complied for legal street driving.
- Working Voltage/Power:12-24V/8.5W, Unlike the untouchable working halogen bulbs, this LED bulb¡¯s power is much lower. save energy and much better heat dissipation.
- Fit: H10 9145 9040 9045 9050 9055 9155 PY20D etc. Perfect replacement for Fog light,Daytime Driving Lights.This bulb can work most cars without flicking or error code, but for some late Japanese/European cars with built in canbus system, or some high powered vehicles, it may require load resistor to avoid hyper flash or malfunction.
- The bulbs equipped with constant-current driving IC and Aluminum Circuit Board. Fast thermal diffusion ,heat-resistant, no digital and VHF radio signal interference.
- NOTE: Please check your vehicle¡¯s manual or the stock bulb to confirm the bulb size before buying. Or you can use the Amazon fitment filter system on left top of this listing, While It may not be 100% accurate or up to date. If your car was not in database, it will also remind ¡°Not fit¡±. So please check your stock bulb for sure.
The ONLY LED headlight bulb that properly works in a halogen headlight reflector that I know of. These are perfect. I have been around HID and LED in Halogen reflectors for a long time. I know since I started is that you cannot put a LED or HID bulb in a Halogen reflector housing and get good results. TOO MUCH GLARE. And some installers don’t care. I have done for retrofits on halogen reflects, converting them to projectors. I think I know what I am talking about when it comes to headlight.Until now.I put the R1 CSP H4’s into a halogen reflector housing, in fact, don’t laugh, it is a…
Bright! Awesome fog lights. Way better than stock. If its hard to plug into housing take of O ring on the light. Iv seen this with tons of products. Dont force it and break clips. Never had any problems with the O rings off. But overall very cool! Matches the led running lights!
Misleading specs Just installed them in my 4Runner for my high beams. It’s a bright light but not 4000lm per bulb. I’m an electrical engineer and have designed led lighting. I put them on my bench and tested them first. Applied voltage from 12 to 24vdc. Power draw for each bulb was about 17 to 18 watts at any voltage. So the PWM driver does a good job at regulation. Issue: spec says 8000lm and 36 watts. What what I measured is 36 watts total for both. Led max out around 100lm per watt. So each bulb can put…