Nilight NI-WA 07 LED Light Bar Wiring Harness Kit 14AWG Heavy Duty 12V On-off Switch Power Relay Blade Fuse for Off Road LED Work Light Bar – ONE Lead,2 Years Warranty

Product features: 12ft extendable wiring harness, one power connector to light fixture illuminated on/off rocker switch, easy to control the on or off of LED lights 12V DC/40A power Relay, blade fuse, multiple safety protection note: maximum Wattage: 380W; operating voltage: 12V DC power please finish the installation by professionals or install the wiring harness under the guidance of professionals.

Product Features

  • Universal fitment: the wiring harness is compatible with all automobiles, boats and devices equipped with a 12V DC power source
  • 12 feet harness: 12ft heavy-duty harness, 14-gauge stranded wire, up to 380W load capacity, the length from relay to switch is extendable
  • Illuminated switch: 3 pin on/off rocker switch with Red Indicator light when truing on, easy to turn on or off, long service life
  • Circuit protection: power relay for safety protection. Blade fuse acts as the first Line of defense against overcurrent and short circuit
  • Package include: 1 x 12 feet wiring harness, 1 x instructions

3 thoughts on “Nilight NI-WA 07 LED Light Bar Wiring Harness Kit 14AWG Heavy Duty 12V On-off Switch Power Relay Blade Fuse for Off Road LED Work Light Bar – ONE Lead,2 Years Warranty”

  1. Very good quality loom and connectors Very good quality loom and connectors. Switch is great. Comes with wiring instructions for the switch which is WONDERFUL! Plus it’s easy to understand. In-line automotive fuses and a decent relay all built in; I can’t build my own harness for what this cost.My only not-quite-complaint is the way the loom is constructed. Its done well, but the power lead to the switch, then to the lights is placed oddly. I had to run the loom across the vehicle and then halfway back so the leads…

  2. Good wiring harness kit for a fast installation I used this kit to install a pair of led lights on my 1997 Kia Sportage. The kit came with everything I needed except for wire ties but that was not an issue. The instructions are easy to understand and with a graphic illustration for wiring the switch. The switch was a little too large to install in the dash without modifying. My Dremel tool took care of that problem but would have been nice not to have to make a bigger opening for it. The length of the harness was about the right length to…

  3. Waterproof! Good light bar with strange optics. The center lighting is higher than the edges, Would have much preferred if the lights were all in the same plane so it could have been mounted inverted. What happens is the leds scatter a lot of light, which makes it a poor fog lamp even though it has a sharp cutoff. I think I’m going to modify the optics by adding a convex lens. Otherwise I’ve driven thru months of monsoon rain at 70+ and no water inside. The light is bluer than expected, the LaminX yellow I…

Leave a Reply

Your email address will not be published. Required fields are marked *