Two Rear Trunk Lid Gas Charged Lift Supports for 1998-2013 Corvette Convertible, 1999-2000 Corvette Base Coupe, 2001-2004 Corvette Z06 Coupe. WGS-175-2

You will receive Two Trunk Lift Supports. Extended Length (measured from center of mounting points): 11.28″, Compressed Length: 7.25″, Rod End Fitting: 5/16″ Ball Socket, Tube End Fitting: 3/8″ Ball Socket. All W.A.S. Lift supports are made with the best quality materials and are backed with a limited lifetime warranty. We Recommend Replacing Both Shocks At The Same Time To Ensure Equal Strength On Both Sides For Proper Performance. This Will Prevent Uneven Load Distribution And Increase The Life Of The Product.

Product Features

  • Unlimited 3 Year Warranty
  • Lifetime Warranty on all Components
  • OEM Quality Replacement
  • Individually Tested For Performance and Reliability
  • Will Not Work On Hatchback Models

3 thoughts on “Two Rear Trunk Lid Gas Charged Lift Supports for 1998-2013 Corvette Convertible, 1999-2000 Corvette Base Coupe, 2001-2004 Corvette Z06 Coupe. WGS-175-2”

  1. 1998 C5 Corvette trunk struts R2. (Remove and Replace) Awesome! 1998 C5. Trunk pops right up 🙂 Flip of the wrist and the trunk opens wide amd stays put!DO NOT MANIPUTE THE CLIPS ON THE NEW STRUTS.Use a screw driver to loosen the clips on the old struts and pop off the ball joint…upper first. Once those are off, the new struts snap right on :)Replace one at a time to avoid smashing your melon or having to prop the trunk lid open.Good luck 👍

  2. 2006 C6 Corvette Convertible Trunk Lid Worked flawlessly. Open trunk lid all the way. Slide a small flat-head driver into the small rounded tabs where the ball joint is on the ones that are there and pull off with a bit of pressure. Should slide off. Take the new ones out of plastic wrapping and orient them the same way as the factory ones. Then just push with a bit of pressure and they should pop on easily. Worked great on my setup to finally open the trunk lid enough to get my hand in there. I wish they made the trunk lid lighter…

  3. These worked on my 2000 Corvette Convertible perfectly. I figured that the reviews on this product were right. They were! I’m happily surprised that these installed just like they should and work very well too… I was tired of my week old struts not opening and supporting the trunk lid properly. This is an inexpensive way to solve that issue. They Look nice, work well and shipped quickly.

Leave a Reply

Your email address will not be published. Required fields are marked *